For Dive Shop Sales
Call 03 5985 1700

  • E-Shark Force Paddleboard Unit

E-Shark Force Paddleboard Unit

$799.00  $719.00
Save: $80.00 (10%)

  • Model: ESA00930
  • Brand: E-Shark Force

Product Description

The E-Shark Force Stand Up Paddleboard (SUP) unit is guaranteed to work well. It connects to the SUP board's ankle strap plug, and stays in the water behind the board as you paddle. The device activates in salt water, and stays active for a good long session from 3-4 hours. The Nylon strap is extremely durable and the device needs only a thorough rinsing in freshwater when you are finished. The charging pad can also be plugged into a computer or portable solar panel, using a USB connection, in areas where there is no ready electrical current. It takes approximately 3 hours to fully charge the E-Shark Force device.

The E-Shark Force SUP unit stays in the water, even as you stand on top of the board with your legs out of the water. It will keep sharks away for 3-4 hours on a charge. It is easy to clean by rinsing with clean water (not salt water), and easy to charge by resting on the charging pad.

E-Shark Force Paddleboard Unit Specifications

  • Depth: 43 metres (140 feet) maximum
  • Power: Internal 3.7 Volt Li-ion battery
  • Battery Charger: 6 VDC, 1.0 Amp wall transformer
  • Charging Time: Approx. 6-8 hours
  • Operational Time: 4-6 hours (in water)
  • Output: 120V to 200V pulsed proprietary wave form
  • Electrodes: 2 stainless steel mesh electrodes

The E-Shark Force Paddleboard Device comes in a clear box that measures 7.2" x 4.5" x 3". It contains the device, a User Manual, and a Qi charging pad: Black Input: DC 5V / 1.5A; Output: 5V / 1A; Frequency: 100 to 200 KHz; Wireless; Distance: 4-10 mm; Dimension: 2.75 x 2.75 x 0.4 in; Weights: 1.5 oz. The charging pad has a 3 foot micro USB to USB cable, so it can connect to anywhere that has a USB outlet: a computer, an outlet converter, a car charger, or some phone chargers.

This E-Shark Force Device charges easily on the charging pad by just resting it so the light comes on. It Uses chip technology with a board and a rechargeable lithium ion battery inside a hard plastic black casing, that easily charges by being set down on the charging disc for 3 hours. There is no need to pull out plugs or screws to charge this new model, and can be charged during a morning or afternoon break. Make sure to charge it before the first use. A full charge should last 3-4 hours. Size: approx 2.5 cm x 6.3 cm x 6.3 cm (1" x 2.5" x 2.5") case on a 6.3 cm (2.5") wide nylon strap.

The SUP unit use a 6.3 cm (2.5") wide and 38.1 cm (15") long nylon strap without the velcro that has it's own rubber loop to hook securely to the SUP leash plug. Each strap is sewn by hand so lengths may vary minutely.

E-Shark Force Scuba Tank Unit Directions

Here is your quick Charging Guide:

  1. Plub enclosed USB cord into outlet with a USB port, or computer USB port.
  2. Plug other end of this cord all the way into the charging pad onthe side.
  3. Make sure the outlet or power source is on.
  4. Gently lay E-Shark Force device with the logo side down onto the top of the charging pad (the side with the red circle).
  5. A Blue light on the pad will quickly come on and go off, indicating that the pad is charging the device.
  6. Wait for at least a full minute before a light on the side of the device shows green, then turns to blinking red to indicate charging.
  7. After device has fully charged (in a few hours), the light will show steady green until you lift the device off the charging pad, ready to wear.

E-Shark Force Comparison Brochure (Adobe PDF, 2 pages, 810 Kb)

(05/16 LRB)